Joined in 2023 
82 
63 About this deal
Rubber or rubber-like materials are widely used in industry and everyday life: for example in seals and rollers, in vibration dampers or for footwear. In general, a whole range of different types of adhesives are suitable for bonding rubber. However, the optimum adhesive always depends heavily on the rubber compound and the intended use. Further information.
PA - polyamide is high-strength and impact-resistant. Its abrasion and wear resistance combined with excellent sliding properties make it a preferred construction material in machine or vehicle construction. Because of its high mechanical strength, it has now even displaced many metal components in vehicle construction - sometimes reinforced with carbon or glass fibres. But PA is not easy to bond. High bond strengths of PA materials require the use of special pre-treatment methods or specially developed, reactive adhesives. Further information. The flowable, red silicone rubber (RTB/HB) has a high heat resistance and low elasticity. They are used as mould construction material for casting moulds for low-melting metals where high hardness is required. VHB™ Tape permanently adheres one substrate to another and spreads the stress load across the entire length of the jointWith this information, the adhesive and surface treatment can be selected based on technical data sheets, experience and the literature. If it is important, adhesive samples should be made and tested before the adhesives are used. In mechanical testing, the bonded joint is loaded until it breaks. The type of fracture provides information about the quality of the bond and indicates where defects occurred during bonding. An adhesion fracture is when the adhesive detaches from the joined part. A cohesion fracture is a fracture in the adhesive itself and a fracture in the part to be joined describes a fracture outside the adhesive surface in the part to be joined.
Designed for use with medium and high surface energy materials like metals, polyimides and polycarbonate In contrast, the low-viscosity, hot-crosslinked silicone rubber (RTV/NV) is medium-elastic, has good flowability and low viscosity. It is therefore particularly suitable for the manufacture of elastic wax or relief casting moulds, casting moulds for figures or decorative panels, moulds for casting with epoxy / casting resin, cement, plaster or other flowable materials. Offering a cleaner application than liquid adhesives, 3M™ Structural Adhesive Tape SAT1010is a single layer epoxy based adhesive tape for the Automotive industry (BIW), formulated for metal bonding applications. This tape is designed to provide structural bonding strength for various applications, specifically for bonding and isolation of dissimilar materials. In addition to bonding performance, the tape features gap filling properties due to its expansion features.Specialist car glues, putty and sealants are hard-wearing products that are built for a life on the road. They’re also able to withstand the weather. We have specialist car tapes too that will help you to carry out rapid repairs and detailed restorations or touch-ups. If you need cable ties, we’ve got those too for those urgent fixes (and for tying up cables too). The tape is typically applied during the body in white process. It is run through the automotive paint pre treatment process and then the e coat process. The tape expands and cures in the e coat cure oven to fill and seal small gaps. The tape forms a continuous barrier between similar and dissimilar materials, which minimizes electrical conductivity and helps prevent galvanic interactions.
Great Deal 
New Comment